Table of Contents
Advertisement
28) Use a drill with a Phillips bit to fasten the (#3) Plastic Pipe Clamp to the ladder as shown below
in Figure 12. The hose clamp should be attached with the top of the clamp aligned with the top
of the step and the side of the clamp against the ladder side rail, See Figure 12. Place (#6) Vinyl
Cap over the tip end of the screw. Repeat this step for each tread on ladder.
2
29) Install the (#2) PVC 90˚ Elbow fitting onto one end of the PVC flex hose using PVC glue. Next
apply glue to the male end of the (#2) Elbow fitting and the female fitting that is pre-installed in
the slide. Connect the (#2) Elbow fitting and hose assembly to the slide while ensuring that the
elbow fitting is oriented so that the hose is aligned with the hose channel in the bottom of the
slide. See Figures 12 and 13.
30) Starting with the top hose clamp, insert the PVC hose into the clamps. The clamps automatically
tighten when pressure is applied pushing the hose into the clamps.
31) Apply PVC glue to one socket of the (#4) PVC Ball Valve and insert the PVC hose into the valve
as shown in Figure 14. Allow the glue sufficient time to dry. The final step is joining the PVC Ball
Valve to the water source.
Install the flex
hose and string
it through the
clamps.
15
Figure 13
Advertisement
Table of Contents
