Setup Example Using The Sfp - Keysight M8195A User Manual

4.3.2

Setup example using the SFP

Keysight M8195A Revision 2 – Arbitrary Waveform Generator User's Guide

Select the waveform segment, that will be executed immediately after starting
the signal generation.
:TRAC:SEL 1
 Start signal generation.
:INIT:IMM
Waveform update and switch operation in a loop until stopped by :ABOR command:
 Reload data into next segment. The <segment_id> is either 1 or 2.
:TRAC:DATA <segment_id>,0,#41280<data-bytes>

Dynamically switch to reloaded segment The <sequence_table_index> is either
0 or 1.
:STAB:DYN:SEL <sequence_table_index>
The following section shows the setup using the SFP.
Preparation:
 Set the continuous mode in the Trigger Tab.
 Set sequencing mode to ARBitrary in the Sequence/Control Tab.

Set dynamic mode in the Sequence/Control Tab.
 Create two waveform segments in the Standard Waveform Tab.

Create two sequence table entries referring to the waveform segments in the
Sequence/Control Tab. Use the "Select Init Segment" field to select the
waveform segment, that will be executed immediately after starting the signal
generation. Send the sequence table to the M8195A.
 Start signal generation by pressing the Run/Stop button.
Streaming 4
147