Keysight M8195A User Manual page 102

2 M8195A User Interface
102
This tab has the following controls:
Sequence/Control Parameters

Sequence Mode
Allows to select a sequence mode (ARBitrary, STSequence, or STSCenario):
 ARBitrary – Generate arbitrary waveform segments
 STSequence – Generate sequences of segments
 STSCenario – Generate scenarios (sequences of sequences)
 Advance Mode
Specifies the advance mode for waveform segment or sequence depending on
selected sequence mode. This option is available only if Arbitrary or
STScenario mode is selected.

Segment Loop
Specifies the number of times a segment will be executed. This option is
available only if Arbitrary mode is selected.

Select Segment
Allows to select the segment that has to be executed. This option is available
only if Arbitrary mode is selected.

Scenario Loop
Specifies the number of times a scenario will be executed. This option is
available only if STScenario mode is selected.

Select Scenario
Allows to select the scenario that has to be executed. This option is available
only if STScenario mode is selected.
 Select Sequence
Allows to select the sequence that has to be executed. This option is available
only if STSequence mode is selected.

Dynamic Control
Enable or disable dynamic sequence control. If dynamic control is switched on,
segments or sequences can be switched dynamically when signal generation
is active. This option is available only if Arbitrary or STSequence mode is
selected.

Select Init Segment
Select the initial segment to be played when dynamic control for segments is
enabled . This option is available only if Arbitrary mode is selected.
 Select Init Sequence
Select the initial sequence to be played when dynamic control for sequences is
enabled. This option is available only if STSequence mode is selected.
 Select Dyn. Sequence
Allows to select the next sequence to be played when dynamic control for
segments or sequences is enabled. This option is available only if Arbitrary or
STSequence mode is selected.
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User's Guide