Assembly - Grizzly G4003G Owner's Manual

Assembly

Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
Assembling the Model G4003G consists of build-
ing the stand assembly, attaching the handwheel
handles, placing and securing the lathe on the
stand, anchoring the stand to the floor, and
attaching the back splash.
To assemble the lathe:
1.
Position left and right cabinets approximately
34" apart in prepared location.
2.
Secure front panel brackets to cabinets with
(4) M6-1 x 10 Phillips head screws and (4)
6mm flat washers (see Figure 10).
Brackets
Cabinets
Figure 10. Brackets installed (rear view).
Model G4003G (Mfd. Since 1/15)
HEAVY LIFT!
x 4
3. Install front panel on panel brackets with (4)
M6-1 x 10 Phillips head screws, (4) 6mm
flat washers, and (4) M6-1 hex nuts (see
Figure 11).
Front Panel
Figure 11. Front panel installed.
Recommended: Use the mounting holes
(approximately ⁄ " in diameter) in the cabi-
3
8
nets (see Figure 12) to mark and drill holes in
the floor, then anchor the stand assembly to
the floor. Use shims to level the assembly as
needed. Refer to Leveling on Page 22 and
Anchoring to Floor on Page 22 for detailed
information.
Figure 12. Locations of cabinet mounting holes
(two on each cabinet).
4.
Remove crate from lathe shipping pallet, then
remove all loose items.
IMPORTANT: Lifting and placing the lathe
requires at least one other person for assis-
tance and a forklift with two lifting straps, lift-
ing chain, and a safety hook rated for at least
2000 lbs. each.
Mounting
Holes
-19-