Spider; Manual Feed - Grizzly G4003G Owner's Manual

Spider

This lathe is equipped with a set of outboard
spindle supports otherwise known as a "spider"
(see Figure 57).
Jam
Nut
Figure 57. Spider components.
Remove spider bolts when not in use.
Always DISCONNECT LATHE FROM POWER
when installing, removing, or adjusting spi-
der bolts. Ignoring this warning can lead to
personal injury or machine damage.
The spider is especially designed for supporting
gun barrels during chambering operations; how-
ever, it is a great support option for almost any
long workpiece that extends through the outboard
side of the spindle.
The tips of the spider bolts have brass wear pads
that hold the workpiece without causing indents
in the finish.
When spider bolts are installed, always use the
jam nuts to lock each spider bolt in position.
Merely tightening the spider bolts against the
workpiece and leaving the jam nuts loose is not
safe. Spiders screws that loosen during operation
can crash into the end gear cover.
-46-
Spider
Bolt

Manual Feed

The handwheels shown in Figure 58 allow the
operator to manually move the cutting tool.
Carriage
Handwheel
Cross Slide
Handwheel
Figure 58. Carriage Controls.
Carriage Handwheel
The carriage handwheel moves the carriage left
or right along the bed. It has a graduated dial with
0.01" increments. One full revolution moves the
carriage 0.70".
Cross Slide Handwheel
The cross slide handwheel moves the tool toward
and away from the work. Adjust the position of
the graduated scale by holding the handwheel
with one hand and turning the dial with the other.
The cross slide handwheel has an indirect-read
graduated dial, which shows the actual distance
the tool moves. The dial has 0.002" (0.05mm)
increments. One full revolution moves the slide
0.200" (5.08mm).
Compound Rest Handwheel
The compound rest handwheel moves the cutting
tool linearly along the set angle of the compound
rest. The compound rest angle is set by hand-
rotating it and securing in place with two hex nuts.
The compound rest has an indirect-read gradu-
ated dial with 0.001" (0.02mm) increments. One
full revolution of the handwheel moves the slide
0.100" (2.54mm).
Model G4003G (Mfd. Since 1/15)
Compound Rest
Handwheel