Table of Contents
Advertisement
Anchoring to Floor
Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware .................
Anchoring machinery to the floor prevents tipping
or shifting and reduces vibration that may occur
during operation, resulting in a machine that runs
slightly quieter and feels more solid.
If the machine will be installed in a commercial or
workplace setting, or if it is permanently connect-
ed (hardwired) to the power supply, local codes
may require that it be anchored to the floor.
If not required by any local codes, fastening the
machine to the floor is an optional step. If you
choose not to do this with your machine, we rec-
ommend placing it on machine mounts, as these
provide an easy method for leveling and they have
vibration-absorbing pads.
Anchoring to Concrete Floors
Lag shield anchors with lag screws (see below)
are a popular way to anchor machinery to a con-
crete floor, because the anchors sit flush with the
floor surface, making it easy to unbolt and move
the machine later, if needed. However, anytime
local codes apply, you MUST follow the anchoring
methodology specified by the code.
Machine Base
Concrete
Figure 9. Popular method for anchoring
machinery to a concrete floor.
-16-
⁄
"
1
2
Lag Screw
Flat Washer
Lag Shield Anchor
Drilled Hole
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble your lathe:
1.
Position the right and left stand legs upright
approximately 57
3
reasonably aligned (see Figure 10).
57
⁄
"
3
4
Figure 10. Supporting legs.
2.
Carefully position the lathe onto the stands
and align the mounting holes.
3.
Secure the lathe assembly to the stand legs
with (8) M10-1.5 x 35 cap screws and 10mm
lock washers, as shown in Figure 11.
x 8
Figure 11. Securing lathe assembly.
Model G0733 (Mfd. Since 5/19)
⁄
" apart, and get them
4
Advertisement
Table of Contents
