Bar Selection (Rudd Bar/Steer Bar/No Bar); Data Pages 1-7 (Data Page) - Raymarine autopilot + ST4000+ Owner's Handbook Manual

104

Bar selection (RUDD BAR/STEER BAR/NO BAR)

Use this screen to select the type of bar graph shown on the display:
•
Mode
Standby
Auto
Track
Wind Vane
•

Data pages 1-7 (DATA PAGE)

The next seven User setup screens allow you to modify the settings
for the data pages. These define the SeaTalk/NMEA data pages that
will be available during normal operation (see page 31). Each setup
page initially shows the title DATA PAGE . After 1 second, the text
changes to the title of the data currently set for that page.The default
settings are:
Data page
1
2
3
4-7
* Note: It is good practice to keep the BTW and DTW for display. If the autopilot
receives a man overboard (MOB) message, these data pages will display the
bearing and distance to the MOB location.
To change the data displayed on a data page:
•
•
ST4000+ Wheel & Tiller Autopilots: Owner's Handbook
STEER BAR: This is the default setting. It uses the bar graph to
indicate different information in different operating modes:
Bar
Rudder bar (for systems with a rudder position sensor)
Heading error bar
Cross track error (XTE) bar
Wind angle error bar
RUDD BAR: This shows the rudder position. If your system
includes a rudder angle sensor, the bar graph will show the true
rudder angle in Standby and Auto modes.
Default setting
XTE (Cross Track Error)
BTW* (Bearing to Waypoint)
DTW* (Distance to Waypoint)
NOT USED (These pages are not displayed when you scroll
through the data pages during normal operation)
Press disp to move to the appropriate data page setup screen.
For each setup page, use the -1 or +1 keys to scroll forwards or
backwards through the available data pages (see following table).