Raymarine autopilot + ST4000+ Owner's Handbook Manual page 93

78
154 mm
(6.1 in)
8. When the pedestal bracket is correctly positioned and aligned,
9. Use a center-punch to mark the center of each slot, then use the
Note: Drill at right angles to the pedestal surface.
10. Hold the bracket in place then lightly tighten the four cross-head
11. Replace the wheel, making sure that you locate the pin in the
12. Turn the wheel with the clutch off to check that the bracket is
ST4000+ Wheel & Tiller Autopilots: Owner's Handbook
mark around the inside of the slots, then remove the bracket.
smaller supplied drill bit to drill a 4.0 mm (
3
screws (No 10 x / in). As you do this, make sure the bracket is
4
correctly aligned.
correct slot (slot 1 or slot 2).
correctly positioned and aligned.
D5346-2
5
/ in) diameter hole.
32
D5344-2