Disengaging The Autopilot (Standby Mode) - Raymarine autopilot + ST4000+ Owner's Handbook Manual
Raymarine wheel & tiller autopilot owner's handbook st4000+
Hide thumbs
Also See for autopilot + ST4000+:
- Owner's handbook manual (130 pages) ,
- Service manual (34 pages) ,
- Quick reference (3 pages)
Table of Contents
Advertisement
Chapter 2: Basic Operation
CAUTION:
Autopilot course control makes it easier to sail a boat, but it is
NOT a substitute for good seamanship. ALWAYS maintain a
permanent watch, no matter how clear the sea appears to be.
Disengaging the autopilot (Standby mode)
1. Press standby .
2. Disengage the autopilot to return to hand steering:
3. The last heading is memorized and can be recalled (see page 9).
CAUTION: Wheel drive systems
On wheel drive systems, always make sure that the clutch is
FULLY DISENGAGED before you leave the boat.
•
in Standby mode, the display shows the boat's current
compass heading.
•
Wheel Pilot: Disengage the wheel drive clutch by rotating the
clutch lever anti-clockwise (so the lever engages fully onto
the locating pip).
•
Tiller Pilot: Remove the drive unit from the tiller pin. If
required, retract the push rod using -1 , +1 , -10 and +10 keys.
7
D3561-2
Hide quick links:
Advertisement
Table of Contents
