Chapter 7: Customizing The St4000 - Raymarine autopilot + ST4000+ Owner's Handbook Manual

Chapter 7: Customizing the ST4000+

Chapter 7: Customizing the ST4000+
The ST4000+ provides calibration options that you can use to adjust
the settings for the control unit, the compass and the autopilot system.
We calibrate the ST4000+ during manufacture to provide stable
performance for most boats so you can perform the initial sea trial.
After you have completed the initial installation and sea trial, you
should not normally need to alter the Dealer setup values. However, if
sailing conditions change you may need to adjust the settings.
Note: Complete the procedures described in Chapter 6: Setting-up
the ST4000+ before adjusting any calibration settings.
The sections in this chapter explain the two setup levels:
7.1
7.2
Accessing the setup modes
Note: See page 40 for more information about the software version
screen.
User setup
This controls compass setup and ST4000+ display
features (bar graph type and data page information).
Dealer setup
This controls the main autopilot settings and also the
calibration lock.
User setup
SECONDS
Software version
SECONDS
101
page 102
page 106
Dealer setup
SECONDS
D5335-1