Moving Your Cooker - Rangemaster 110 User's Manual & Installation Instructions

Moving your cooker

Switch off the electricity supply.
The cooker is heavy, two people may be
required to move it. The cooker is fitted
with one roller at the front and two at
the back. There are also two screw
down levelling feet at the front.
The front roller, designed for moving the
cooker can be wound down. The levelling tool
which controls this roller is in the storage
drawer compartment.
Remove the storage drawer (by pulling
it right out and lifting it up slightly)
and you should see the levelling tool.
Your installer may not have left the levelling
tool in place. If not, locate it as shown. If you
cannot find the levelling tool, contact your
installer. See the inside front cover of your
INSTALLATION GUIDE.
Turn the levelling tool clockwise, two
full (180º) turns. It will be stiff. The
front of the oven will rise slightly as the
roller drops down.
Open the grill door and right hand oven door
so that you can get a good grip on the bottom
of the fascia panel as you move the oven.
Do not move the oven by pulling the
hand rail, door handles or knobs.
Move the oven a bit at a time, checking behind
it to make sure the gas hose is not caught. Make
sure both electricity and gas cables have
sufficient slack to move the cooker forward as
you go along.
If a stability chain is fitted, release it as
you ease the cooker out.
When you replace the cooker, wind it down off
the rollers by turning the levelling tool anti-
clockwise. This is important. It will stop the
cooker moving accidentally, while in use.
16