How To Enter Programming Mode; Permanent Update Procedure; How To Reset The System - Vertical MXB IP Hardware Installation Manual

Basic Preprogramming

How to Enter Programming Mode

To enter programming mode, perform the following steps:
1. Lift handset or press the [MON] button on the ADMIN station; the ICM dial tone
(optional) will be presented.
2. Press the [TRANS/PGM] button and dial *#; the confirmation tone will be heard.
3. Enter the ADMIN password (if applicable); the station will be in ADMIN programming
mode (confirmation tone is heard).
4. Each program is accessed by pressing the [TRANS/PGM] button; the following will
display:
5. Enter the three-digit program number; if an error is made while entering data, the
[TRANS/PGM] button will return to the previous status.
:
NOTE

Permanent Update Procedure

To commit data entered to permanent memory, perform the following steps:
1. When data has been entered, press the [HOLD/SAVE] button to permanently store
the data; if all data was entered correctly, a confirmation tone will be heard.
2. If there were any errors in the entry, an error tone will be presented and data is not
stored in the permanent memory, and the terminal will return to the previous state.

How to Reset the System

To reset the system:
1. Press the [Trans/PGM] button.
2. Dial 499 (Reset System Code).
3. Press the FLEX2 button.
4. Press [HOLD/SAVE]. NOTE: The system should be reset after entering PGM100 -
FLEX 1 (Nation Code Assign).
Release 1.0
To return the previous state while in ADMIN programming, press the [CONF]
button; pressing the [CONF] button will clear the temporary data fields.
Enter P G M Nu mber
MBX IP Hardware & Installation Guide
Chapter 7: Starting the MBX IP System
7-3
November 2010