Configuring Ipv6 Bidir-Pim; Ipv6 Bidir-Pim Configuration Task List; Configuration Prerequisites - H3C S5500-EI Configuration Manual
Switch series
Hide thumbs
Also See for S5500-EI:
- Operation manual (1529 pages) ,
- Configuration manual (457 pages) ,
- Security configuration manual (448 pages)
Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Enter IPv6 PIM view.
3.
Disable the switchover to
SPT.
Configuring IPv6 BIDIR-PIM
IPv6 BIDIR-PIM configuration task list
Task
Enabling IPv6 PIM-SM
Enabling IPv6 BIDIR-PIM
Configuring an RP
Configuring a BSR
Configuring IPv6 administrative
scoping
Configuring IPv6 PIM common features
Configuration prerequisites
Before you configure IPv6 BIDIR-PIM, complete the following tasks:
Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
•
domain can communicate with each other at Layer 3.
Determine the IPv6 address of a static RP and the IPv6 ACL that defines the range of IPv6 multicast
•
groups to which the static RP is designated.
Command
system-view
pim ipv6
spt-switch-threshold infinity
[ group-policy acl6-number
[ order order-value ] ]
Configuring a static RP
Configuring a C-RP
Enabling embedded RP
Configuring C-RP timers globally
Configuring a C-BSR
Configuring an IPv6 BIDIR-PIM domain border
Configuring global C-BSR parameters
Configuring C-BSR timers
Disabling BSM semantic fragmentation
Enabling IPv6 administrative scoping
Configuring an IPv6 admin-scope zone boundary
Configuring C-BSRs for each admin-scope zone
399
Remarks
N/A
N/A
Optional.
By default, the device switches to the SPT
immediately after it receives the first IPv6
multicast packet from the RPT.
Remarks
Required.
Required.
Required.
Use any approach.
Optional.
Required.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Advertisement
Table of Contents
Troubleshooting
