Step
7.
Enable IPv6 PIM snooping in
the VLAN.
Displaying and maintaining IPv6 PIM snooping
Task
Display IPv6 PIM snooping
neighbor information.
Display IPv6 PIM snooping routing
entries.
Display the statistics information of
IPv6 PIM messages learned by IPv6
PIM snooping.
Clear the statistics information of
IPv6 PIM messages learned by IPv6
PIM snooping.
IPv6 PIM snooping configuration example
Network requirements
As shown in
sends multicast data to IPv6 multicast group FF2E::101. Receiver 1 belongs to multicast group FF1E::101,
and Receiver 2 belongs to multicast group FF2E::101. Router C and Router D run MLD on their interface
GigabitEthernet 1/0/1. Router A, Router B, Router C, and Router D run IPv6 PIM-SM, and interface
GigabitEthernet 1/0/2 on Router A acts as a C-BSR and C-RP.
Configure MLD snooping and IPv6 PIM snooping on Switch A so that Switch A forwards IPv6 PIM
messages and multicast data to only the routers that are interested in the multicast data.
Command
pim-snooping ipv6 enable
Figure
76, Source 1 sends multicast data to IPv6 multicast group FF1E::101, and Source 2
Command
display pim-snooping ipv6
neighbor [ vlan vlan-id ] [ slot
slot-number ] [ | { begin | exclude
| include } regular-expression ]
display pim-snooping ipv6
routing-table [ vlan vlan-id ] [ slot
slot-number ] [ | { begin | exclude
| include } regular-expression ]
display pim-snooping ipv6
statistics [ | { begin | exclude |
include } regular-expression ]
reset pim-snooping ipv6 statistics
310
Remarks
Disabled by default
Remarks
Available in any view
Available in any view
Available in any view
Available in user view