H3C S5500-EI Configuration Manual page 259

An MSDP peering relationship is set up between Switch A and Switch C and between Switch C and
Switch D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2 sends
multicast data to multicast group 227.1.1.0/30.
Configure SA message filtering rules so that receivers Host A and Host B can receive only the multicast
data addressed to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Host can receive only the
multicast data addressed to multicast groups 226.1.1.0/30 and 227.1.1.0/30.
Figure 65 Network diagram
PIM-SM 1
Receiver
Host A
Source 1
Device
Source 1
Source 2
Switch A
Switch B
Configuration Procedure
Configure the IP address and subnet mask for each interface as per
1.
Configure OSPF on the switches to make sure the switches are interoperable at the network-layer,
2.
and they can dynamically update their routing information. (Details not shown.)
Enable IP multicast routing, IGMP and PIM-SM, and configure a PIM domain border:
3.
# On Switch A, enable IP multicast routing, enable IGMP on the host-side interface,
VLAN-interface 100, and enable PIM-SM on each interface.
Loop0
Vlan-int100
Switch A
Vlan-int200
Switch B
MSDP peers
Interface IP address
— 10.110.3.100/24
— 10.110.6.100/24
Vlan-int100 10.110.1.1/24
Vlan-int102 10.110.2.1/24
Vlan-int101 192.168.1.1/24
Loop0 1.1.1.1/32
Vlan-int200 10.110.3.1/24
Vlan-int102 10.110.2.2/24
Vlan-int103 192.168.2.1/24
PIM-SM 2
Loop0
Switch C
Vlan-int104
Vlan-int300
Receiver
Host B
Device
Switch C
Switch D
240
PIM-SM 3
Source 2
Vlan-int400
Vlan-int104
Switch D
Vlan-int500
Receiver
Host C
Interface
Vlan-int300
Vlan-int104
Vlan-int101
Vlan-int103
Loop0
Vlan-int400
Vlan-int500
Vlan-int104
Loop0
Figure 65. (Details not shown.)
IP address
10.110.4.1/24
10.110.5.1/24
192.168.1.2/24
192.168.2.2/24
2.2.2.2/32
10.110.6.1/24
10.110.7.1/24
10.110.5.2/24
3.3.3.3/32