H3C S5500-EI Configuration Manual page 320
Switch series
Hide thumbs
Also See for S5500-EI:
- Operation manual (1529 pages) ,
- Configuration manual (457 pages) ,
- Security configuration manual (448 pages)
Table of Contents
Advertisement
Figure 74 Network diagram
Configuration procedures
Enable IPv6 forwarding and configure an IP address and prefix length for each interface as
1.
per
Figure
Configure Switch A:
2.
# Create VLAN 101 through VLAN 104 and assign GigabitEthernet 1/0/1 through
GigabitEthernet 1/0/4 to the four VLANs respectively.
<SwitchA> system-view
[SwitchA] vlan 101
[SwitchA-vlan101] port gigabitethernet 1/0/1
[SwitchA-vlan101] quit
[SwitchA] vlan 102
[SwitchA-vlan102] port gigabitethernet 1/0/2
[SwitchA-vlan102] quit
[SwitchA] vlan 103
[SwitchA-vlan103] port gigabitethernet 1/0/3
[SwitchA-vlan103] quit
[SwitchA] vlan 104
[SwitchA-vlan104] port gigabitethernet 1/0/4
[SwitchA-vlan104] quit
# Enable IPv6 multicast routing. Enable IPv6 PIM-DM on VLAN-interface 101, VLAN-interface 102
and VLAN-interface 104, and enable MLD on VLAN-interface 104.
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 dm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim ipv6 dm
[SwitchA-Vlan-interface102] quit
74. (Details not shown.)
301
Advertisement
Table of Contents
Troubleshooting
