Relationship Among Ipv6 Pim Protocols - H3C S5500-EI Configuration Manual

Figure 103 Building an SPT in IPv6 PIM-SSM
Source
Server
As shown in
report message to the respective DRs to announce that they are interested in the information about the
specific IPv6 multicast source S and that sent to the IPv6 multicast group G.
The DR that has received the report first determines whether the IPv6 group address in this message falls
into the IPv6 SSM group range and then does the following:
If the IPv6 group address in the message does fall into the IPv6 SSM group range, the IPv6 PIM-SSM
•
model is built. The DR sends a channel subscription message hop by hop toward the IPv6 multicast
source S. An (S, G) entry is created on all routers on the path from the DR to the source. Thus, an SPT
is built in the network, with the source S as its root and receivers as its leaves. This SPT is the
transmission channel in IPv6 PIM-SSM.
If the IPv6 group address in the message does not fall into the IPv6 SSM group range, the DR follows
•
the IPv6 PIM-SM process. The receiver-side DR sends a (*, G) join message to the RP, and the
source-side DR registers the IPv6 multicast source.

Relationship among IPv6 PIM protocols

In an IPv6 PIM network, IPv6 PIM-DM cannot work with IPv6 PIM-SM, IPv6 BIDIR-PIM, or IPv6 PIM-SSM.
However, IPv6 PIM-SM, IPv6 BIDIR-PIM, and IPv6 PIM-SSM can work together. When they work together,
which one is chosen for a receiver trying to join a group depends, as shown in
RP
SPT
Subscribe message
IPv6 multicast packets
Figure 103, Hosts B and C are IPv6 multicast information receivers. They send an MLDv2
DR
384
Host A
Receiver
DR
Host B
Receiver
Host C
Figure 104.