H3C S5500-EI Configuration Manual page 144

Figure 38 Network diagram
Device
Source 1
Source 2
Switch A
Switch B
Configuration procedure
Configure the IP address and subnet mask of each interface as per
1.
Configure OSPF on the switches in the PIM-SM domain to make sure the switches are interoperable
2.
at the network layer and they can dynamically update their routing information. (Details not
shown.)
Enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP and IGMP SSM
3.
mapping on the host-side interface:
# Enable IP multicast routing on Switch D, enable PIM-SM on each interface, and enable IGMPv3
and IGMP SSM mapping on VLAN-interface 400.
<SwitchD> system-view
[SwitchD] multicast routing-enable
[SwitchD] interface vlan-interface 400
[SwitchD-Vlan-interface400] igmp enable
[SwitchD-Vlan-interface400] igmp version 3
[SwitchD-Vlan-interface400] igmp ssm-mapping enable
[SwitchD-Vlan-interface400] pim sm
[SwitchD-Vlan-interface400] quit
[SwitchD] interface vlan-interface 103
[SwitchD-Vlan-interface103] pim sm
[SwitchD-Vlan-interface103] quit
[SwitchD] interface vlan-interface 104
Interface IP address
— 133.133.1.1/24
— 133.133.2.1/24
Vlan-int100 133.133.1.2/24
Vlan-int101 192.168.1.1/24
Vlan-int104 192.168.4.2/24
Vlan-int200 133.133.2.2/24
Vlan-int101 192.168.1.2/24
Vlan-int102 192.168.2.1/24
Device Interface
Source 3 —
Receiver —
Switch C Vlan-int300
Vlan-int103
Vlan-int102
Switch D Vlan-int400
Vlan-int103
Vlan-int104
125
IP address
133.133.3.1/24
133.133.4.1/24
133.133.3.2/24
192.168.3.1/24
192.168.2.2/24
133.133.4.2/24
192.168.3.2/24
192.168.4.1/24
Figure 38. (Details not shown.)