flow-control { hardware | none | software }
undo flow-control
View
User interface view
Default level
2: System level
Parameters
hardware: Performs hardware flow control.
none: Performs no flow control.
software: Performs software flow control.
Description
Use flow-control to configure flow control mode.
Use undo flow-control to restore the default.
By default, no flow control is performed.
A flow control mode takes effect on both inbound and outbound directions. In inbound flow control, the
local device listens to the remote device for flow control information while in the outbound flow control,
the local device sends flow control information to the remote device.
The flow control mode setting on one end must be the same as that in the outbound/inbound direction
on the other end.
NOTE:
The router does support hardware and software flow control.
•
The command is only applicable to asynchronous serial interfaces, including AUX and console ports.
•
The flow control settings must be consistent for the user interfaces of the connecting ports on the
•
redirection device and the terminal device for communication.
Examples
# Configure software flow control in the inbound and outbound directions for port console 0.
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] undo flow-control software
free user-interface
Syntax
free user-interface { num1 | { aux | console | vty } num2 }
View
User view
Default level
3: Manage level
30