Operating Modes & Programming - SecEng SED-64 Installation & User Manual

1.5
BASIC BACK UP SYSTEM
1
Connect the phone line to the
customers alarm panel to the female side ,connect the RJ lead as shown
in 1.1 to the SED-64 Wire the GSM fault relay into a 24Hr zone on the
customers alarm panel.
INTELLIGENT BACK UP SYSTEM
2
(WE RECOMMENDED THAT THE INTELLIGENT MODE BE USED IN MOST CASES)
Connect the phone line to the male side of the T-socket and the
customers alarm panel to the female side, connect the RJ lead as
shown in 1.1 to the SED-64. Wire the fault relay into a 24Hr zone on
the customers alarm panel. Power up the SED-64 and program
functions 1, 2 & 3. For programming details see Section 2.0 of this
manual Ensure the control room has set up the communication
Template on 2.10
FULL TIME
3
INSTALLED)
Program Function 07 for GSM Full Time (option=0) and connect the
customers alarm panel to the female side of the T-socket.
(You can also wire the RJ lead from the alarm panel to RJ on the
SED-64 CON1 directly without using the T-socket)
GPRS SUPERVISED POLLING
4
Phone 1300 65 44 33 to activate GPRS supervised polling
.
There are 2 available methods to program the SED-64
Manual Mode
Plug a standard telephone butt into the SED-62/64 Port marked
"CON1" and program as per Section 2.1
SMS Mode
Send a formatted text messages via SMS from any mobile phone to
program as per Section 2.2.
Operating Modes & Programming
Operating Modes
(IF THERE IS NO PHONE LINE OR WILL NEVER BE
Programming
(Section 2.1)
(Section 2.2)
male side of the T-socket and the
OR
9