Advertisement
Quick Links
SED-900
Handheld V2 & Master
Wireless System
WARNING: PLEASE READ
INSTALLATION INSTRUCTIONS
FIRST
PRODUCT WARRANTY
This product is covered by a 12 month, back to base warranty from date of purchase,
and proof of purchase should be supplied. The warranty does not cover damage that
has resulted from the improper installation or improper use of this product.
The warranty does not cover lightning damage, product misuse, electrical surges or
acts of God.
LIMITATION OF LIABILITY
Sec Eng Systems Pty Ltd does not accept any liability for the loss or damage to
property or persons in relation to goods supplied. This disclaimer is only limited to the
warranty of the goods supplied and the intended use.
NOTE: THIS MANUAL IS SUBJECT TO COPYRIGHT
SEC-ENG SYSTEMS SYDNEY AUSTRALIA
Phone 02-9524 9952
www.seceng.com.au
Advertisement
Related Manuals for SecEng SED-900
Summary of Contents for SecEng SED-900
- Page 1 SED-900 Handheld V2 & Master Wireless System WARNING: PLEASE READ INSTALLATION INSTRUCTIONS FIRST PRODUCT WARRANTY This product is covered by a 12 month, back to base warranty from date of purchase, and proof of purchase should be supplied. The warranty does not cover damage that has resulted from the improper installation or improper use of this product.
- Page 2 READ THIS PLEASE The do’s and don'ts of installing our wireless equipment 1/ always install the antenna’s that we supply Outside 2/ Always install our antennas a minimum 3 metre away from each other or any other antenna’s 3/ If you are installing multiple Sed 900’s systems in one location, call us so we can assist you with the best possible Installation process void your warranty...
-
Page 3: Access Control
INSTALLATION START HERE Wireless System Overview The Sed 900 is designed to allow a wireless reader on a handheld to operate back to a master control station, and provide full wiegand control. The master control station has 2 wiegand outputs that are selectable from the hand held. -
Page 4: Led Indicators
Sed 900 master guide CONNECTION GUIDE FOR MASTER SED 900 SED 900 master LEDS power charging Access signal control Output XXXX TX Data data data clock clock MASTER Rx Data reader 1 A-Request beep beep A-Reply ------ ------ B-Request Battery in Output XXXX B-Reply data... - Page 5 SED 900 TESTING AND SETUP HAND HELD POWER UP Note: If the unit has an external charger fitted it will automatically power up the hand held when connected, and power down when removed TURNING HAND HELD ON Press and hold the front power switch down until the out light comes on then let it go The following leds should appear when on and running Rf = radio link ok...
- Page 6 SED 900 Commissioning Testing unit 1/ Ensure the following leds are on • Pwr • Rf ok 2/ Ensure IN or Out are selected 3/ When a card is presented to reader the following should occur; card Tx and Rx leds will flicker and the reader will beep Access or Denial is just like a wired reader NOTE: if you are in a poor signal area or...
-
Page 7: Technical Specifications
Technical specifications Radio transmission 915--928Mhz Power output: 1000Mw Type: Spread spectrum freq hopping Security encryption: 56 bit DES Handheld Battery: NI-MH 10 x AA 2300 Ma Austel compliance N3884 Sed 900 fault Sequence To be able to read the fault indication You must wait for the ( chg led ) and ( Lbatt led ) to flash together 5 times this will be followed by the Lbatt led...