Nexcom Peak 555A User Manual page 63

Peak 555A User's Guide
This item allows you to determine which Infra Red (IR) function of
onboard I/O chip. The Choice: Standard
IrDA1.1
Duplex Select
This item allows you to select the IR function when your select the UART 2
Mode is IrDA1.0, ASK-IR, IrDA1.1
Choices are Half, Full.
TxD, RxD Active
This item allows you to determine the active of RxD, TxD.
Choices are "Hi, Hi", "Lo, Lo", "Lo, Hi", "Hi, Lo".
Onboard Parallel Port
Select a logical LPT port name and matching address for the physical parallel
(printer) port. The choice: 378H/IRQ7
Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel port. Select Compatible or
Extended unless you are certain both your hardware and software support
EPP or ECP mode.
The choice: SPP, ECP+EPP1.7, EPP1.7+SPP, EPP1.9+SPP, ECP,
ECP+EPP1.9
(Default)
ECP Mode Use DMA
Select a DMA channel for the port.
Choices are 3
(Default)
BIOS Setup
(Default)
, and Normal.
, 1.
, IrDA1.0, ASK-IR,
(Default)
, 278H/IRQ5, 3BCH/IRQ7,
4- 33