Holzmann DKS 20 User Manual page 9

SETUP
NOTE: Hardware to mount this scroll saw to a bench or leg set is NOT supplied. See mounting instructions
for recommended hardware size.
ASSEMBLY:
Remove the pvc pipe from the loose parts bag, attach it to the sawdust blower tube and the bellows lock
on the top of the housing.
INSTALL / CHANGE SAW BLADE:
1. Rotate the blade tension knob counterclockwise to release blade tension.
2. Remove table insert and remove blade from the inner upper and lower blade holders by pulling
forward on blade and then lifting the blade through the access hole in the table. Slight downward
pressure against the upper holder may be helpful when removing blade from upper holder.
3. Look at the blade holders closely and notice the Blade slots and pin recesses in the blade holders.