Reversed Inlet Supplies - Mira Select Flex Installation And User Manual

reVerSed inlet SUPPlieS

the Mira Select Flex thermostatic mixer is
supplied with inlet connections Hot - Left, Cold
- Right and Outlet - Bottom (exposed models),
Outlet - Top (built-in models) as standard. If
the hot and cold water supply pipes have been
reversed during installation, the thermostatic
cartridge must be removed and rotated 180°.
Exposed Models
1. isolate the hot and cold water supplies and
operate the flow control lever to relieve
pressure and drain any residual water.
2. Unscrew the grubscrew with a 2.5 mm
hexagonal key and pull off the temperature
control and flow control levers.
3. Pull off the bearing.
4. rotate the white section of the control lever
interface 90° clockwise and pull off.
5. Pull off the flow lever adaptor.
Flow lever
adaptor
control lever
interface
Flow control
lever
6. Locate the 'O' key (supplied) onto the cartridge
nut and turn anticlockwise. Unscrew fully and
pull the cartridge from the mixer body.
7. rotate the cartridge 180°.
cartridge Seal
Bearing
temperature
control lever
'o' Key
8. Make sure that the two inlet seals are fitted
and carefully push the cartridge back into the
mixer body, aligning the lugs into the slots.
Note! check that the cartridge lug stamped
'h' is aligned with the hot inlet supply.
Important! take care when fitting the
cartridge. damage to the cartridge inlet seals
may result in dripping from the showerhead.
9. tighten the nut by turning the 'o' key
clockwise.
10. r e f i t t h e c o n t r o l s i n r e v e r s e o r d e r.
Before using the shower, refer to section:
'Commissioning'.
Built-in Models
1. isolate the hot and cold water supplies and
operate the flow control lever to relieve
pressure and drain any residual water.
2. Unscrew the grubscrew and pull off the
temperature control lever, bearing and flow
control lever.
3. carefully unclip the concealing plate from the
backplate.
Note! Use a screwdriver in the cutout to assist
separation.
Backplate
cutout
20
concealing Plate
Flow control
lever
Bearing
temperature
control Knob