Table of Contents
Advertisement
Maintenance
Inlet Filter - Cleaning/Renewing
Read the section
Make sure that electrical supply is
turned off at mains and water supply
is fully turned off.
Remove three screws. Carefully
remove the cover.
Remove service tunnel.
Hold suitable wrench across flats of
metal connector. Unscrew filter using
another wrench as shown. Clean or
renew filter as necessary. Refit in
reverse order making sure filter is
screwed fully home.
Do not overtighten. Make sure plumbing
connections are tight before restoring
electricity and water supplies. Check
for leaks.
Refit service tunnel and cover. Make
sure they fit correctly. Do not overtighten
screws.
"Important Safety Information"
first
Service
Tunnel
26
Cover
Filter
Advertisement
Table of Contents
