Operation - Mira Select Flex Installation And User Manual

4. Unscrew the two backplate screws and remove
the backplate.
5. Pull off the red flow lever adaptor.
6. Locate the 'O' Key (supplied) onto the cartridge
nut and turn anticlockwise. Unscrew fully and
pull the thermostatic cartridge from the mixing
valve.
thermostatic
cartridge
Flow lever adaptor
Backplate
7. rotate the thermostatic cartridge 180°.
8. Make sure that the two inlet seals are fitted
and carefully push the thermostatic cartridge
back into the mixing valve, aligning the lugs
into the slots.
Note! check that the cartridge lug stamped
'h' is aligned with the hot inlet supply.
Important! take care when fitting the
thermostatic cartridge. damage to the cartridge
inlet seals may result in dripping from the
showerhead.
9. tighten the nut by turning the 'o' key
clockwise.
10. Refit the controls in reverse order.
Note! When refitting the bearing, make sure
that the cutouts are aligned with the control
assembly.
11. Before using the shower, refer to section:
'Commissioning'.
'o' Key

oPeration

the Mira Select Flex is a thermostatic mixer
with separate control levers for on/off and
temperature.
turn the Flow control
lever anticlockwise to
the preset maximum flow
OFF
ON
21
Cooler
turn the temperature control
lever clockwise to decrease
t h e t e m p e r a t u r e a n d
anticlockwise to the preset
maximum temperature
Warmer