Mira Select Flex Installation And User Manual page 11

5. cut away the plasterboard and/or brick work
to the required depth.
Important! this depth 'x' will depend on the
finished wall thickness e.g. tiles or facia board.
refer to the table for this measurement.
For stud partitions depth 'x' refers to the
distance from the rear mounting e.g. timber
noggin, to the front of the wall (before tiling).
rear Mounting (Solid
Wall or Timber Noggin)
depth 'x'
Finished Wall thickness
(e.g. tile and adhesive)
4 mm
6 mm
8 mm
10 mm
12 mm
14 mm
16 mm
18 mm
20 mm
22 mm
24 mm
Finished Wall
Surface
Finished Wall
thickness
Wall cutout depth
'x'
81 - 63 mm
79 - 61 mm
77 - 59 mm
75 - 57 mm
73 - 55 mm
71 - 55 mm
69 - 55 mm
67 - 55 mm
65 - 55 mm
63 - 55 mm
61 - 55 mm
6. Refit the building-in shroud to the mixer using
the two shroud screws removed earlier.
7. Make sure that the mixer is level and central
in the hole, and square to the finished wall
surface (or the control components will not fit
correctly), then mark the positions of two fixing
screw holes on the wall.
8. For solid walls drill two 6 mm holes for the wall
plugs.
9. Fit the hot and cold supply pipework (Hot -
Left, Cold - Right).
10. Caution! It is essential at this point
that the supply pipework is thoroughly
flushed through before connection to the
mixer. Failure to do so may result in product
malfunction and will not be covered under the
guarantee.
11