Connecting Electricity And Water Supplies - Mira JUMP Installation And User Manual

3. Remove the installation template
and drill the fixing holes. Insert the
supplied wall plugs.
Caution! Do not drill into buried pipes
or cables.
4. Remove the cover and service tunnel
from the Mira Jump shower. Keep the
retaining screws (x3) for later use.
5. The case has thinned sections that
can be removed to allow entry of the
electrical cables. Remove either of the
top thinned sections of the case for a
falling supply.
6. Adjust the shower inlet for water
supply pipe position if required.
Continue to "Connecting Electricity
and Water Supplies" to complete the
installation
Connecting Electricity and
Water Supplies
1.
Flush the inlet water pipe through to
clear any debris.
2.
Connect the inlet supply pipe to the
shower inlet using a 1/2" BSP nipple
with compression nuts and olives
(as shown) or a push-fit connector.
3. Fix the shower to the wall with the
supplied screws.
4.
If the water inlet is rear fed, make sure
the elbow fitting can be removed for
filter maintenance post installation.
( s e e s e c t i o n " M a i n t e n a n c e -
Cleaning the Inlet Filter".)
BELOW
16
REAR
SIDE
Inlet Connector
Compression Nut
Olive
1/2'' BSP Nipple
Olive
Compression Nut
Inlet Supply