Table of Contents
Advertisement
Any maintenance must be carried out by a qualified tradesperson, following the
instructions provided. Before replacing any parts, ensure that the underlying cause
of the malfunction has been resolved.
Warning! There are no user-serviceable components beneath the cover of the
appliance. Only a competent tradesperson should remove the cover.
Cleaning
Many household and industrial cleaners contain abrasives and chemical substances
that can damage the finish of your shower. Only clean the shower and fittings with a
mild washing-up detergent or soap solution, and then wipe them dry with a soft cloth.
Cleaning the Inlet Filter
Warning! Isolate the electrical and water
supplies before removing the cover.
1.
Remove the three screws that hold
the cover on the shower and remove
the cover.
2.
Remove the service tunnel from the
shower.
3.
Use a suitable spanner to remove
the filter from the inlet connector
assembly. Hold a wrench across the
flats of the inlet connector assembly
to prevent damage to the connector,
whilst removing the strainer.
4.
Remove the inlet filter.
5.
Clean the inlet filter with a stiff brush.
If necessary, use a kettle descalent in
accordance with the manufacturer's
instructions.
6.
Refit the components in reverse order.
MAINTENANCE
22
Screws
Cover
Service Tunnel
Inlet Filter
Inlet Connector
Assembly
Screw
Advertisement
Table of Contents
