Inlet Filter - Cleaning/Renewing - Mira Alero Installation And User Manual

WARNING
There are no user serviceable parts inside the shower.
Servicing of the shower must only be carried out by qualified, competent
personnel following the instructions provided in this guide and those provided
with any spare part.
Before replacing any parts, ensure that the underlying cause of the malfunction
has been resolved.

Inlet Filter - Cleaning/Renewing

Read the section "Important Safety Information" first
Make sure that the electrical supply
is turned off at the mains and that the
water supply is fully turned off.
Remove the three screws and the
cover.
Caution! Handle the glass cover
assembly with care.
Hold a wrench across the flats of the
metal connector. Unscrew the filter
using another wrench as shown. Clean
or renew the Filter as necessary. Refit
in reverse order making sure the Filter
is screwed fully home.
Do not overtighten! Make sure
plumbing connections are sealed
before restoring electricity supply.
Refit the cover making sure it is
correctly located. Do not overtighten
the screws.
SERVICING
25
Cover Retaining
Screw
Cover
Filter