Figure 34-6: Mg Monitoring Window - AudioCodes Mediant 8000 Installation, Operation & Maintenance Manual

Installation & Operation Manual
6.
Click the
Each parameter is measured using either Gauges or Counters. Gauges are
indicated by
selected the Graph view then you cannot select parameters measured by both
Gauges and Counters.
7.
Select the parameters group for which you wish to display performance
measurements (e.g., MG IP).
All parameters for the selected Parameter Group are displayed.
8.
Check the desired parameters from the Parameter Group. You may select up to 5
parameters in the same entity (select a total of 10 parameters) or compare
parameters over different entities (e.g. over different trunks or boards).
9. Click OK button to return to the Real-Time Performance Measurement Display
window.
10.
In the Real-Time Performance Measurement Display window, choose polling
interval and click the Start Polling button
Version 6.6
Parameters button. The MG Monitoring (RT) window is displayed.

Figure 34-6: MG Monitoring Window

and Counters are indicated by
407
34. Performance Measurements
. For each PM query, if you
to start polling.
October 2014