B.3.4 Example Configuration Output - AudioCodes Mediant 8000 Installation, Operation & Maintenance Manual

Installation & Operation Manual
B.3.4 Example Configuration Output
This section illustrates example command line output for the Cisco CLI commands
specified in this section. Separate examples are illustrated for configuring the
3560_G1, 3560_G2 and 3560_G3 Cisco switches.
The following data illustrates example output for the Cisco command show running-
config for the 3560_G1 switch:
Note:
port-channel load-balance dst-ip
!
interface Port-channel1
!
interface Port-channel2
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
channel-group 1 mode active
!
interface GigabitEthernet0/3
channel-group 1 mode active
!
interface GigabitEthernet0/4
channel-group 1 mode active
!
interface GigabitEthernet0/5
channel-group 2 mode active
!
interface GigabitEthernet0/6
channel-group 2 mode active
!
interface GigabitEthernet0/7
channel-group 2 mode active
!
interface Vlan1
ip address 10.7.16.10 255.255.0.0
!
ip route 10.77.10.0 255.255.255.0 10.7.16.5
ip route 10.77.11.0 255.255.255.0 10.7.16.5
ip route 10.77.12.0 255.255.255.0 10.7.16.5
Version 6.6
For ES-2 switch, use command "channel-group XXX mode on".
B. Appendix - Configuring HSRP/VRRP
895 October 2014