Default Settings - Cisco Nexus 3000 Series Configuration Manual

Default Settings

S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
Default Settings
Table 9-1
Table 9-1
Parameters
Configured VRFs
routing context
Configuring VRFs
This section contains the following topics:
•
•
•
•
•
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.
Creating a VRF
You can create a VRF in a switch.
SUMMARY STEPS
1.
2.
3.
4.
5.
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
9-6
lists the default settings for VRF parameters.
Default VRF Parameters
Creating a VRF, page 9-6
Assigning VRF Membership to an Interface, page 9-7
Configuring VRF Parameters for a Routing Protocol, page 9-9
Configuring a VRF-Aware Service, page 9-10
Setting the VRF Scope, page 9-12
configure terminal
vrf context name
ip route {ip-prefix | ip-addr ip-mask} {[next-hop | nh-prefix] | [interface next-hop | nh-prefix]} [tag
tag-value [pref]
(Optional) show vrf [vrf-name]
(Optional) copy running-config startup-config
Chapter 9 Configuring Layer 3 Virtualization
Default
default, management
default VRF