Cisco Nexus 3000 Series Configuration Manual page 128

Configuring Virtualization for EIGRP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
vrf context vrf-name
Example:
switch(config)# vrf context
RemoteOfficeVRF
switch(config-vrf)#
Step 3
router eigrp instance-tag
Example:
switch(config)# router eigrp Test1
switch(config-router)#
Step 4
interface ethernet slot/port
Example:
switch(config)# interface ethernet 1/2
switch(config-if)#
Step 5
no switchport
Example:
switch(config-if)# no switchport
Step 6
vrf member vrf-name
Example:
switch(config-if)# vrf member
RemoteOfficeVRF
Step 7
ip router eigrp instance-tag
Example:
switch(config-if)# ip router eigrp Test1
Step 8
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
4-26
Purpose
Enters configuration mode.
Creates a new VRF and enters VRF configuration
mode. The VRN name can be any case-sensitive,
alphanumeric string up to 20 characters.
Creates a new EIGRP process with the configured
instance tag. The instance tag can be any
case-sensitive, alphanumeric string up to 20
characters.
If you configure an instance-tag that does not qualify
as an AS number, you must use the
autonomous-system command to configure the AS
number explicitly or this EIGRP instance will remain
in the shutdown state.
Enters interface configuration mode. Use ? to find the
slot and port ranges.
Configures the interface as a Layer 3 routed interface.
Adds this interface to a VRF. The VRF name can be
any case-sensitive, alphanumeric string up to 20
characters.
Adds this interface to the EIGRP process. The instance
tag can be any case-sensitive, alphanumeric string up
to 20 characters.
(Optional) Saves this configuration change.
Chapter 4 Configuring EIGRP