Cisco Nexus 3000 Series Configuration Manual page 302

Configuring VRRP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
For interface state tracking to function, you must enable preemption on the interface.
Note
VRRP does not support Layer 2 interface tracking.
Note
BEFORE YOU BEGIN
Ensure that you have enabled the VRRP feature (see the
Ensure that you have configured an IP address on the interface (see the
section on page
Ensure that you have enabled the virtual router (see the
page
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
interface interface-type slot/port
Example:
switch(config)# interface ethernet 2/1
switch(config-if)#
Step 3
no switchport
Example:
switch(config-if)# no switchport
Step 4
vrrp number
Example:
switch(config-if)# vrrp 250
switch(config-if-vrrp)#
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
13-16
2-7.
13-8).
configure terminal
interface interface-type slot/port
no switchport
vrrp number
shutdown
track interface type number priority value
no shutdown
(Optional) show vrrp
(Optional) copy running-config startup-config
"Configuring VRRP" section on page
"Configuring IPv4 Addressing"
"Configuring VRRP Groups" section on
Purpose
Enters configuration mode.
Enters interface configuration mode.
Configures the interface as a Layer 3 routed interface.
Creates a virtual router group.
Chapter 13 Configuring VRRP
13-7).