Verifying Object Tracking Configuration; Object Tracking Example Configuration; Related Topics; Default Settings - Cisco Nexus 7000 Series Configuration Manual

Verifying Object Tracking Configuration

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
Verifying Object Tracking Configuration
To verify object tracking configuration information, use the following commands:
Command
show track [object-id] [brief]
show track [object-id] interface [brief]
show track [object-id] {ip | ipv6} route [brief]

Object Tracking Example Configuration

This example shows how to configure object tracking for route reachability and use VRF Red to look up
reachability information for this route:
switch# config t
switch(config)# track 2 ip route 209.165.201.0/8 reachability
switch(config-track)# vrf member Red
switch(config-track)# copy running-config startup-config

Related Topics

See the following topics for information related to object tracking:
•
•
•

Default Settings

Table 21-1
Table 21-1
Parameters
Tracked Object VRF

Additional References

For additional information related to implementing object tracking, see the following sections:
•
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
21-14
Chapter 14, "Configuring Layer 3 Virtualization"
Chapter 18, "Configuring GLBP"
Chapter 19, "Configuring HSRP"
lists the default settings for object tracking parameters.
Default Object Tracking Parameters
Related Documents, page 21-15
Chapter 21
Purpose
Displays the object tracking information for one
or more objects.
Displays the interface-based object tracking
information.
Displays the IPv4 or IPv6 route-based object
tracking information.
Default
Member of default VRF
Configuring Object Tracking
OL-20002-02