Verifying The Rip Configuration; Displaying Rip Statistics - Cisco Nexus 3000 Series Configuration Manual

Chapter 7 Configuring RIP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
Command
ip rip metric-offset value
Example:
switch(config-if)# ip rip metric-offset 10
ip rip route-filter {prefix-list list-name
| route-map map-name | [in | out]
Example:
switch(config-if)# ip rip route-filter
route-map InputMap in

Verifying the RIP Configuration

To display the RIP configuration information, perform one of the following tasks:
Command
show ip rip instance [instance-tag] [vrf
vrf-name]
show ip rip [instance instance-tag] interface
slot/port detail [vrf vrf-name]
show ip rip [instance instance-tag] neighbor
[interface-type number] [vrf vrf-name]
show ip} rip [instance instance-tag] route
[ip-prefix/lengh [longer-prefixes |
shorter--prefixes]] [summary] [vrf vrf-name]
show running-configuration rip

Displaying RIP Statistics

To display the RIP statistics, use the following commands:
Command
show ip rip [instance instance-tag] policy
statistics redistribute {bgp as | direct |
{eigrp | ospf | ospfv3 | rip} instance-tag |
static} [vrf vrf-name]
show ip rip [instance instance-tag]
statistics interface-type number] [vrf
vrf-name]
Use the clear ip rip policy command to clear policy statistics.
Use the clear ip rip statistics command to clear RIP statistics.
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Purpose
Adds a value to the metric for every router received
on this interface. The range is from 1 to 15. The
default is 1.
Specifies a route map to filter incoming or outgoing
RIP updates.
Purpose
Displays the status for an instance of RIP.
Displays the RIP status for an interface.
Displays the RIP neighbor table.
Displays the RIP route table.
Displays the current running RIP configuration.
Purpose
Displays the RIP policy status.
Displays the RIP statistics.
Verifying the RIP Configuration
7-17