Table of Contents
Advertisement
CamiFlex Base Unit – Head Unit
1 INTRODUCTION
1.1 Caution – safety instructions
Please, read these instructions and heed all warnings.
- Do not use this apparatus near water.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
- For a full warranty, only use attachments/accessories specified by the manufacturer.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
- This device has to be installed by qualified personnel who knows the usual safety procedures and
also follows the recommendations listed in this manual.
- The Base Unit chassis MUST be connected to a power supply with a proper grounding. This power
connector (IEC 320) is the main connector for the network disconnection and must be easily
accessible.
- Both Base Unit and Head Unit must be connected together thanks to hybrid fiber. Connection Base
Unit or Head Unit to another equipment can cause failure and such use may cancel the guarantee.
- The mechanical ground of the equipment must be grounded. It is necessary to use an AC cord with
Earth as the one supplied. If you choose to use another power cord, make sure it is appropriate.
100-240V ~
50/60Hz
1A max
- Real consumption is depending on the power camera need: Lowest consumption value is around
0.3A
- Do not open the equipment when power supply is connected, otherwise there is a risk of electric
shock and death.
Camera does not allow to be powered off by unpluging the DC IN but must be powered down thanks
to camera switch off first.
Turning off the equipment is done with the front panel button.
FOUGEROLLE will not be responsible of any accident to a person or any damage to the equipment
after use of the product without following these safety recommendations. Such use may cancel the
guarantee.
In accordance with current standards, this unit is equipped with a unipolar protection by fuse.
F4AH 5x20
IEC 127
This means that a voltage is always present in the equipment when the power cord is connected to AC
power. Do not remove the cover of the equipment without unplug the power cord.
-4-
Advertisement
Table of Contents
