Yaesu FTM-400DR Instruction Manual page 91

15
Enter the time
The entered time will be displayed at the top of the
screen.
A time between 10 sec and 180 sec can be set.
Tip Factory default value: 120 sec
16
Touch [ENT]
17
Select and touch [6 TURN ANGLE]
The number input screen will be displayed.
Set the minimum angle for determining whether the
direction of advance has changed.
18
Enter the angle
The entered angle will be displayed at the top of the
screen.
An angle between 5° and 90° can be set.
Tip Factory default value: 28°
19
Touch [ENT]
20
Select and touch [7 TURN SLOPE]
The number input screen will be displayed.
Set the coefficient for dynamically changing the angle
that is used to determine changes in the direction of
advance depending on the movement speed. The
larger the coefficient value, the larger is the criteria
angle at low speeds.
1 - 255 (X10)°/speed
(the unit for the rotating tilt is set to one-tenth of the
real number so it will be consistent with the unit used
in the HamHUD series from HamHUD Nichetronix).
21
Enter the coefficient
The entered coefficient will be displayed at the top of
the screen.
A value between 1 and 255 can be set.
Tip Factory default value: 26°
22
Touch [ENT]
23
Select and touch [8 TURN TIME]
The number input screen will be displayed.
Set the time limit until the next beacon can be sent
after a beacon has been transmitted due to a change
detected in the time (Variable Rate Beaconing) and
direction of advance (Corner Pegging).
90