wtw photolab S12 Operating Instructions Manual page 95

17. Technical Data
Software settings when delivered
ID number input:
Measured value
number:
blank value is:
Reference absorbance: Off
turbidity correct.:
language:
Kinetic interval:
Date of the last valid
AQA1 check:
AQA1 interval:
AQA2 interval:
AQA password:
AQA mode:
Lock measurement if
AQA2 expired:
Checks to be measured
with AQA1:
AQA2 values:
Settings after reset - total
Measured value storage and setup reset
Settings after reset - meas. storage
Meas. value number:
Measured values:
Settings after reset - setup
ID number input:
Measured value
number:
blank value:
reference absorbance: Off
turbidity correct.:
Language:
Kinetic interval:
Citation forms of the
methods
Units of the methods:
Settings after reset - AQA
Date of the last valid
AQA1 check:
AQA1 interval:
AQA2 interval:
AQA password:
AQA mode:
Lock measurement if
AQA2 expired:
Checks to be measured
with AQA1:
AQA2 values:
Off
1
Off
Off
English
60s
invalid (not yet measured)
12 weeks
4 weeks
0000
Off
Off
none
none
1
none
Off
1
Off
Off
unchanged
60s
respective reference cita-
tion
respective reference unit
invalid (not yet measured)
12 weeks
4 weeks
0000
Off
Off
none
(Input theoretical values and tolerances
are not erased and are offered again
with the next input).
none
(theoretical values and tolerances of all
methods are set to default values
®
according to the "Spectroquant
CombiCheck and standard solutions"
table in the part "General information".)
71