Other Commands - EXFO FLS-2600B User Manual

Remote Control

Other Commands

Other Commands
Description This function is used to save the following sweep setup
Syntax
Parameters The <number> parameter represents the number you want to
Example
Note
Description This function is used to recall a sweep setup saved in your list.
Syntax
Parameters The <number> parameter represents the number of the item
Example
Note
126
parameters:
start wavelength, end wavelength, mode, speed, length,

cycles, reverse, trigger for continuous sweep
start wavelength, end wavelength, mode, step, pause,

cycles, reverse, trigger for step-by-step sweepYou can save
up to five configurations.
SOUR:SWE:SAVE<wsp><number>
use in the Save list. You can choose a number from 1 to 5.
SOUR:SWE:SAVE 2
You cannot use this command during a sweep.
SOUR:SWE:RECA<wsp><number>
you want to recall. You can choose a number from 1 to 5.
SOUR:SWE:RECA 3
You cannot use this command during a sweep.
SOURce:SWEep:SAVE
SOURce:SWEep:RECAll
FLS-2600B