Audio Board - HP Envy x2 Maintenance And Service Manual

Audio board

Description
Audio board (includes cable)
Before removing the audio board, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
the following components:
Battery (see
▲
Remove the audio board:
1. Release the ZIF connector attaching the audio board cable to the system board (1), and detach the cable
from the back cover (the audio board cable is attached to the back cover with double-sided adhesive in
two locations) (2).
2. Remove the one Phillips PM2.0×2.5 screw (3) that secures the audio board to the back cover.
3. Remove the audio board (4).
Reverse this procedure to install the audio board.
Display panel assembly on page
Battery on page 36)
Spare part number
L05096-001
32), and then remove
Component replacement procedures 45