Touchscreen Board Cable - HP Envy x2 Maintenance And Service Manual

Touchscreen board cable

Description
Touchscreen board cable (includes double-sided adhesive)
Before removing the Touchscreen board cable, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
the following components:
▲ Battery (see
Remove the Touchscreen board cable:
1. Remove the two Phillips PM2.0×2.5 screws (1) that secure the bracket to the enclosure, and then
remove the bracket (2).
2. Release the ZIF connector (3) to which the Touchscreen board cable is connected, and then disconnect
the Touchscreen board cable from the system board.
3. Detach the Touchscreen board cable (4) from the back cover. (The Touchscreen board cable is attached
to the back cover with double-sided adhesive.)
4. Remove the Touchscreen board cable.
Reverse this procedure to install the Touchscreen board cable.
42 Chapter 5 Removal and replacement procedures
Display panel assembly on page
Battery on page 36)
Spare part number
L05095-001
32), and then remove