Power Button Board - HP Envy x2 Maintenance And Service Manual

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
the following components:
Battery (see
▲
Remove the power button board:
1. Release the power button board cable from the ZIF connector on the system board (1), and then remove
the power button board (2).
2. Remove the power button board and cable.
Reverse this procedure to install the power button board.
Display panel assembly on page
Battery on page 36)
Spare part number
L05098-001
32), and then remove
Component replacement procedures 47