HP Envy x2 Maintenance And Service Manual page 41

Hide thumbs Also See for Envy x2:

Table of Contents

Use a heating gun to heat the top (1) and left (2) and right edges of the tablet to release the adhesive

securing the display panel assembly to the back cover.

Use a case utility tool (3) or similar thin, plastic tool, and the suction cups to separate the display panel

assembly (4) from the back cover.

Remove the suction cups.

CAUTION:

Before releasing the display panel assembly, make sure the work surface is clear of tools,

screws, and any other foreign objects. Failure to follow this caution can result in damage to the display

panel assembly.

Swing the display panel assembly (1) forward until it rests upside down in front of the back cover.

Release the zero insertion force (ZIF) connector (2) to which the Touchscreen board cable is connected,

and then disconnect the Touchscreen board cable from the display panel assembly (3).

10.

Release the ZIF connector to which the display panel cable is connected, and then disconnect the display

panel cable (5) from the display panel assembly.

Component replacement procedures

Table of Contents