D Scan Function; Selecting A Frequency - Icom IC-M700PRO Instruction Manual

D Scan function

The scan function allows you to automatically search
for signals with a group of channels. There are 2 scan
types (selectable in the set mode) as follows:
Channel scan
ch 2
ch 1
ch 50
Channel resume scan
ch 2
ch 1
ch 50

■ Selecting a frequency

The transceiver has 0.5 to 30.0 MHz general cover-
age receive capability, with 100 Hz resolution. Use the
VFO mode to select frequencies around the prepro-
grammed channels in the memory mode.
☞
N OTE: Frequencies selected in the VFO mode are
for temporary use and are not stored in memory.
q While in the memory mode, rotate the [GROUP]
and [CHANNEL] selectors to select the channel
nearest the frequency you want.
w Push [CH/FREQ] to select the VFO mode.
• "FREQ" appears.
e Rotate the [CHANNEL] selector to select the de-
sired frequency.
• The frequency changes in 100 Hz steps.
ch 3
scan is
cancelled
ch 4
when
transmitting
ch 5
ch 3
scan pauses
for 10 seconds
ch 4
after the squelch
opens,
then resumes
ch 5
SELECTING A CHANNEL/FREQUENCY
Scan operation
q Rotate the [GROUP] selector to select the group
you wish to scan.
w If necessary, push [SQL] to close the squelch.
• "SQL" appears.
e Push [SCAN] to start scanning.
• "SCAN" appears.
r Push [SCAN] again to stop scanning.
• "SCAN" disappears.
SIMP
SQL
1.6 MHz selected
SIMP
SQL
1.6001 MHz selected
3
Rotate
[CHANNEL]
to select a
frequency in
100 Hz steps
6