Icom IC-M700PRO Instruction Manual page 15

(4) Scan speed
Selects scan speed as follows:
2 3 4 5 6
2 3 4 5 6
Faster
(5) CW/FSK narrow filter
This selects the passband width for CW (A1A), FSK
or J2B mode.
☞ N OTE: When "ON" is selected without the optional
filter installed, the transceiver does not function in
these modes.
(6) FSK frequency shift
Several shift settings (the difference between the
mark and space frequency) are used for FSK opera-
tion. This item allows you to select a shift setting for
almost any FSK system.
(7) FSK polarity
Normal and reverse polarities are available for FSK
operation. This item allows you to select one of these
polarities.
"FK-REV OFF" (normal):
key open (mark); key close (space)
"FK-REV ON" (reverse):
key open (space); key close (mark)
(8) CW break-in
The CW break-in function (in A1A mode) toggles
transmit and receive with CW keying. Full break-in al-
lows you to receive signals between transmitted key-
ing pulses during CW transmission. Semi break-in
allows you to mute receiving until keying stops with
a delay time.
(unit: sec./ch)
7 8 9 10
7 8 9 10
Slower
5
SET MODE
Fastest scan speed
(default)
Slowest scan speed
Passband:
2.3 kHz/ 6 dB
(default)
Passband:
500 Hz/ 6 dB
Frequency shift:
170 Hz
(default)
Frequency shift:
425 Hz
Frequency shift:
850 Hz
FSK normal
(default)
FSK reverse
Full break-in
Automatic keying without
delay time (default)
Semi break-in
Automatic keying with delay
time
OFF
Manual transmission
necessary for keying
12