Display - Icom IC-M700PRO Instruction Manual

■ Display

ALM
RX
q
TUNE
w
TX
e
q RECEIVE INDICATOR
Appears while receiving and when the squelch is
open.
w TUNE INDICATOR (p. 8)
Flashes while the connected antenna tuner, such
as Icom's AT-130, is being tuned.
• Tuning starts when transmitting on a new frequency or
pushing the [TUNE] switch.
e TRANSMIT INDICATOR
Appears when transmitting.
r S/RF METER
➥ Shows the relative received signal strength while
receiving.
➥ Shows output power while transmitting.
t CHANNEL/VFO INDICATOR (p. 5)
➥ Shows the selected group and channel in the
memory mode.
➥ "FREQ" appears in the VFO mode.
y SQUELCH INDICATOR (p. 9)
Appears when the squelch is ON.
!3
D U P SIMP
r t
!2 !1
SQL NB
SCAN
y u
u SCAN INDICATOR (p. 6)
Appears when the scan function is in use.
• The scan function is not available on some versions.
• Pushing [SCAN] starts and stops the scan.
i NOISE BLANKER INDICATOR (p. 9)
Appears when the [NB] switch is turned ON.
o AGC OFF INDICATOR (p. 9)
Appears when the [AGC] switch is pushed to indi-
cate the AGC function is deactivated.
!0 MODE READOUT
Shows the selected operating mode (type of emis-
sion).
!1 SPEAKER OFF INDICATOR
Appears when the [SPEAKER] switch is pushed to
indicate the front panel speaker is deactivated.
!2 FREQUENCY READOUT
➥ S hows the selected frequency whether in the
memory mode or the VFO mode. (p. 5)
➥ Shows the transmit frequency (for duplex
channels) when transmitting or when pushing
[TX FREQ]. (p. 8)
!3 SIMPLEX/DUPLEX INDICATORS
These appear to show whether the selected chan-
nel is simplex or duplex.
• In the VFO mode, only simplex channels are available.
• No indicator means that there is no transmit frequency
programmed.
PANEL DESCRIPTION
!0
AGC AGC
o
i
2
4