Fixture Settings; Display Settings; Fixture Test - ProLights PIXIEWASH User Manual

16

3.12 FIXTURE SETTINGS

You can change the parameters for the device by following these steps:
• Press the button LEFT to enter the menu mode.
• Use the buttons UP/DOWN to select the System setup item. Press the button ENTER to confirm.
• Press the buttons UP/DOWN to select the desired option item and press the button ENTER to confirm:
- Master/Slave - This configuration allows to connect many units PIXIEWASH. The first will be set as
Master and the others will work as Slave with the same effect. Press the buttons UP/DOWN to set the
units as master or slave. Press the button ENTER to confirm. Use PIXIEWASH DMX connectors and
XLR cable to do a units chain.
- White Balance - White Balance function. Select the White Balance function to set the white balance by
changing the values (125-255) of the colors Red, Green and Blue.
- Dimmer Mode - Adjusting the dimmer. Enter in Dimmer Mode to select specific dimming curve.
Particularly when set:
• Off: The increase in light intensity is linear
• Dimmer 1: Light intensity control is finger at low levels and coarse at high levels.
• Dimmer 2: Light intensity control is finger at high levels and coarse at low levels.
• Dimmer 3: Light intensity control is finger at low levels and high levels and coarse at medium levels.
- Fan Mode - Fan speed. Select the desired fan speed High Speed or Auto Speed through the button UP/
DOWN.
- Factory Settings - Factory reset. Select Factory Settings function and then Yes to restore all values to the
original factory settings.
• Press repeatedly the button LEFT to return the menu mode.

3.13 DISPLAY SETTINGS

• Press the button LEFT to enter the menu mode.
• Press the buttons UP/DOWN to select the Display setup item. Then press the button ENTER.
• Press the buttons UP/DOWN to select the desired option item and press the button ENTER to confirm:
- Display Inverse - Used for reversing display. Select Display Inverse, press ENTER button to confirm, present
mode will blink on the display, use UP/DOWN button to select No (normal display) or Yes (inverse dis-
play), press ENTER button to store.
- Back Light - Display backlight. Select Back Light, press ENTER button to confirm. Use the UP/DOWN keys
to select On for display always on or Off for setting display off one minute after the exit from the menu.
- Warn Cue - Select Warn Cue, press ENTER button to confirm, present mode will blink on the display, use
UP/DOWN button to select No (Normal) or Yes (display will show the error warning when the unit
went wrong).
• Press repeatedly the button LEFT to return the menu mode.

3.14 FIXTURE TEST

Auto Test
Allow checking the proper functioning of the unit. Start the automatic test in the following way:
• Press the button LEFT to enter the menu mode.
• Use the buttons UP/DOWN to select the Test Setup item. Press the button ENTER to confirm.
• Press the buttons UP/DOWN to select the Auto Test item.
• To confirm and start the automatic test press the ENTER button.
PiXiEWASH