Ddtmf Transmission; D Receiving A Stun, Kill And Revive Command - Icom iF3200DEX series Operating Instructions Manual

Vhf/uhf digital/analog transceivers

Table of Contents

BASIC OPERATION

Receiving and transmitting (Continued)

DTMF transmission

If the transceiver has [DTMF Autodial] assigned to it,

you can use the automatic DTMF transmission func-

tion.

Push [DTMF Autodial] to transmit the DTMF code.

➥

Receiving a Stun, Kill and Revive command

The dispatcher can send a command signal that will

stun, kill or revive your transceiver.

When the Stun command is received, a beep sounds*,

and the transceiver becomes unusable. Receiving a

Revive command is necessary to operate the trans-

ceiver again in this case.

When the Kill command is received, a beep sounds*,

and the transceiver becomes unusable. Cloning the

transceiver is necessary to operate the transceiver

again in this case.

*Depending on the presetting.

3-6

Table of Contents

Chapters

Table of Contents

Do you have a question about the iF3200DEX series and is the answer not in the manual?

If4200dex series